Safety Operating Procedures for Pet Food Production Lines

Oct 17, 2025

Leave a message

Pet food extrusion production lines are complex systems integrating raw material processing, high-temperature and high-pressure extrusion, cooling and molding, and other processes. Their safety operating procedures must be formulated to address the high-temperature, high-pressure, and high-speed operating characteristics of the extrusion process, as well as the risk of dust explosions. The following details general safety standards, key operating points for core equipment, and emergency response:

 

I. General Safety Operating Procedures

1. Personnel Qualifications and Protection Requirements

Certification: Operators of special equipment such as extruders and pressure vessels must hold a "Special Equipment Operator Certificate." New employees must pass three levels of safety training (company, workshop, and job-specific) and assessments.

Personal Protective Equipment (PPE): Wear long-sleeved flame-retardant work clothes and non-slip shoes. When handling high-temperature parts, wear high-temperature resistant gloves (temperature resistance ≥200℃) and goggles.

During crushing and mixing processes, wear a dust mask (such as an N95 mask) to prevent dust inhalation.

 

2. Pre-Start Safety Inspection

Equipment Status Confirmation: Check the clearance between the extruder screw and the cylinder (usually ≤0.5mm), confirm that the cutter and die are securely installed, and that the protective cover is not loose.

Verify the effectiveness of the safety interlock devices (e.g., the equipment cannot start if the door is not closed) and the emergency stop button (the equipment should stop within 3 seconds after being pressed).

Electrical and Instrumentation Inspection: Confirm that the grounding resistance of the distribution box is ≤4Ω, and that the pressure gauges and temperature sensors (accuracy ±1℃) are within their calibration validity period. The range of the steam pipeline pressure gauge must cover 1.5-2 times the rated pressure.

 

3. In-Operation Safety Monitoring

Real-Time Parameter Monitoring: Control the extrusion chamber temperature at 140-180℃, maintain the pressure at 0.6-0.8MPa, and immediately alarm and adjust if it exceeds the rated value by 10%.

The main motor current must not exceed 85% of the rated current to avoid overload and motor burnout.

Prohibited Activities: It is strictly forbidden to open the feed inlet observation window while the extruder is running (this may cause hot material to spray out). Do not insert tools into the cylinder for stirring.

When the conveyor belt is running, do not cross over it or stand underneath it to avoid injury.

 

Send Inquiry